Fixing Of Reduction Gear - Allmatic IND4000K Manuel D'emploi

FIXING OF REDUCTION GEAR

Open the packaging and check the condition of all the parts of the automation.
Remove the lid unscrewing the screws see (fig. 5).
Place the reduction gear on the plate.
Insert the 4 washers + locknuts to fix the gear (fig. 6).
If the allowed adjustment of the ratchet is not sufficient it is possible to compensate the height of the
reduction gear working on the 4 more external screws (fig.6).
Once the adjustment is finished firmly fix the 4 locknuts, making sure that during the entire run of the
gate, the reduction gear is firmly to the ground.
NUTS FOR FIXING THE
REDUCTION GEAR
SCREWS FOR THE HEIGHT
ADJUSTMENT OF THE
REDUCTION GEAR
18
REMOVE THE
4 M6 SCREWS
Fig. 5
Fig. 6