Safety; Safety Standards; Equipment - Allmatic IND4000K Manuel D'emploi

SAFETY

Congratulations on your choice of our product.
This manual will aid you in installing your reduction gear.
As you read through it, you will find not only explanations on the operation of the reduction gear, but also on
safety standards that you must comply with for perfect operation and maximum safety.
To prevent damage to your unit and to avoid injury to yourself or others, before installing the reduction gear
and its components, carefully read all of the following information on safety standards.
Keep this information so that anyone who will be using the unit can refer to it.
No liability shall be accepted for the consequences of failure to comply with the precautions provided.
! If the unit malfunctions, shut it off immediately.
! When making repairs, make sure the electrical supply is disconnected.
! Do not attempt to disassemble the unit if you are not an authorized installer.
! Do not expose to flames or sources of heat. Do not immerge in water or other liquids.
! Use suitable power cables.
! Supervise the door when it is moving. Keep people away from it until it is completely open or closed.

SAFETY STANDARDS

During installation and use of this automation, carefully follow these safety standards:
USE GLOVES!
ATTENTION!
SAFE DISTANCE!
USE WELDING
GOGGLES!

EQUIPMENT

To install the automation, you will need the following equipment: wrenches, screwdrivers, tape measure,
level, saw, drill, welder.
ATTENTION! DO
NOT INSTALL THE
AUTOMATION IN
ENVIRONMENTS
THAT ARE
SATURATED WITH
EXPLOSIVE
MIXTURES!
13
ATTENTION!
MECHANISMS IN
MOVEMENT!
LEAVE GUARD IN
PLACE!
ATTENTION!
ELECTRICAL SHOCK!
GB