Pre -Operation & Safety Inspection - Upright SL-26NBE Guide De L'opérateur

I
NTRODUCTION
This manual covers the operation of the SL26/30
Narrow Work Platform with Bi-Energy power option.
This manual must be stored on the machine at all
times.
P -O
RE PERATION
Carefully read, understand and follow all safety
rules, labels, and operating instructions. Then
perform the following steps each day before
use.
1. Remove module covers and inspect for damage,
oil leaks or missing parts.
2. Check the level of the hydraulic oil with the plat-
form fully lowered. Oil should be visible in the
sight gauge. Add hydraulic oil if necessary (see
Specifications , page 10).
3. Check that the fluid level in the batteries is correct
(see Battery Maintenance , page 7).
4. Carefully inspect the entire work platform for
damage, such as cracked welds or structural
members, loose or missing parts, oil leaks, dam-
aged cables or hoses, loose connections and tire
damage.
5. Check that all guardrails are securely in place
with all fasteners properly torqued.
6. Place the Chassis Emergency Stop Switch to the
position by pulling the button out.
ON
7. Check fuel supply.
8. Check engine oil level with dipstick.
9. While the engine is cool, check the radiator cool-
ant level.
DO NOT
or radiator is hot.
10. Verify batteries are charged (see Battery Mainte-
nance , page 7).
11. Check that AC extension cord has been discon-
nected from the charger.
H
ydraulic Tank
e
Sight Gaug
Emergency
Lowering Switch
Figure 1: Control Module, Chassis Left Side
3
& S I
AFETY NSPECTION
check coolant when the engine
Chassis
Chassis Lift
Emergency
Switch
Stop Button
Glow/Start
Chassis/Platform
Switch
Key Switch