Cleaning And Maintenance Instructions; Daily Maintenance - Climadiff AIRPUR20 Notice D'utilisation

8. Sensor sensitivity adjustment
Sensor sensitivity can be adjusted:
 Press the "SPEED" button in standby mode (when the unit is switched on but not lit) for several
seconds, each speed will light up, release the button to set the desired sensitivity:
LOW
MID
HIGH
Note: when using the camera for the first time, or reconnecting the camera, the sensitivity of the default
sensor is "Moderate".
Tips: The device uses an odor sensor that is sensitive to hydrogen, carbon monoxide, methane, ethanol
and other gases, and is insensitive to formaldehyde but cannot detect dust, pollen, and Other particles,
and does not affect the purification effect of the above pollutants. If the air quality indicator is blue, it means
that the odor concentration is low, if it is orange the concentration is average, and if it is red, the
concentration is high.

7. CLEANING AND MAINTENANCE INSTRUCTIONS

Before servicing or cleaning, make sure the unit is unplugged. When replacing filters, it is best to wear
gloves and put the used filters in a plastic bag before discarding them to prevent "secondary pollution" from
the environment due to pollutants in the filter. Check the front and rear of each filter for proper installation.

8. DAILY MAINTENANCE

Precautions:
- It is recommended to use a small soft brush or an interior vacuum cleaner.
- It is only necessary to clean the filter side at the air inspiration, not the back of the filter (except the
1. Clean the appliance with a soft cloth.
Regularly remove dust from the body and from the air outlets and inlets
to prevent accumulation.
2. HEPA filter cleaning.
After the filter light turns on, you can clean the filter with a vacuum
cleaner or a brush.
21