Starting And Stopping - Ryobi RBC430SESD Manuel D'utilisation

use.
■ Install the cutting line. Refer to "String replacement" in
the manual for additional information.
OPERATION
WARNING
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a
second is suffi cient to infl ict serious injury.
WARNING
Always wear safety goggles or safety glasses with
side shields when operating power tools. Failure to do
so could result in objects being thrown into your eyes
resulting in possible serious injury.
WARNING
Keep all bystanders, especially children and pet, at
least 15 m away.
WARNING
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING
Beware of the emission of exhaust gases.
FUELING AND REFUELING
■ Clean the surface around the fuel cap to prevent
contamination.
■ Loosen the fuel cap slowly. Rest the cap on a clean
surface.
■ Pour the fuel carefully into the tank. Avoid spillage.
■ Clean and inspect the gasket prior to replacing the fuel
cap.
■ Replace the fuel cap immediately and hand tighten it.
Wipe up any fuel spillage.
NOTE: It is normal for the engine to emit smoke during
and after the fi rst use.
English (Original instructions)
Always shut the engine off before fueling. Never add
fuel to a machine with a running or hot engine. Move
at least 10 m away from refueling site before starting
engine. Do not smoke! Failure to heed this warning
could result in serious personal injury.
ADDING/CHECKING ENGINE LUBRICANT
See fi gure 16.
Engine lubricant has a major infl uence on engine
performance and service life. For general, all-temperature
use, SAE 20W-50 is recommended. Always use a 4-stroke
motor lubricant that meets or exceeds the requirements.
NOTE: Non-detergent or 2-stroke engine lubricants will
damage the engine and should not be used.
To add engine lubricant:
■ Remove the cap and seal from lubricant bottle
■ Screw the funnel to the lubricant bottle, and then
■ Unscrew the oil cap/dipstick and remove.
■ Add the entire bottle of engine lubricant through oil fill
■ Reinstall the oil cap/dipstick and secure.
To check engine lubricant level:
■ Set engine on a flat surface unscrew the oil cap
■ Wipe the dipstick clean and re-seat in hole; do not re-
■ Remove dipstick again and check lubricant level.
■ If level is low, add engine lubricant until the fluid level
■ Replace and secure the oil cap/dipstick.
Do not overfi ll. Overfi lling the crankcase may cause
-excessive smoke and engine damage.

STARTING AND STOPPING

To start a cold engine:
See fi gure 9a.
For RBC430SESD
■ Lay the trimmer on a flat, bare surface.
■ Press the primer bulb 10 times.
■ Set the choke lever to the
■ Keep the throttle trigger squeezed completely.
23
WARNING
provided.
remove the small red cap from the funnel.
hole.
dipstick and remove.
screw.
Lubricant level should fall within the hatched area on
the dipstick.
rises to the upper portion of the hatched area on the
dipstick.
CAUTION
choke position.