Onscreen Messages - 3M 800 Série Guide De L'utilisateur

M ™ Digital Media System 800 Series
Common Problems and Solutions
Symptom
The remote control does not work.

Onscreen Messages

Message
No input is detected.
Please change the lamp.
There are (x) hours of lamp life remaining.
The unit will shut off in 40 minutes.
There are (x) hours of lamp life remaining.
The unit will shut off in 5 minutes.
© M 2006. All Rights Reserved.
Cause
The remote control is not facing
the remote control sensor.
The remote control is too far from
the sensor.
An obstruction is between the
remote control and the sensor.
The remote control's batteries are
exhausted or inserted wrong.
Meaning
Projector is not receiving a signal from an external
source. Check the cable connections and verify
power is on and external source is working.
The lamp has 1400–1499 hours on it and needs to
be changed.
The lamp has 1500–1579 hours on it and needs to
be changed.
When the lamp has 1580 hours or more on it, the
message will flash, and the power will turn off after 5
minutes.
Troubleshooting
Solution
Face the remote control toward
the remote control sensor.
Operate the remote control within
5 meters.
Remove obstacle.
Correctly insert batteries.
27