Pioneer UDP-LX500 Mode D'emploi page 41

Setting Options
Digital Output Bitstream
PCM
Reencode
Off
Stereo
Downmix
Lt/Rt
48kHz
Max Sampling
Frequency
96kHz
192kHz
• When playing back a sampling frequency file or a disk having a lower than or equal setting compared to the
present setting, you can output it at the unchanged sampling frequency.
• Sources with sampling frequencies of over 192 kHz cannot be played.
• When playing copyright-protected discs or files, the signals are output with the sampling frequency limited to
48 kHz or below, regardless of this setting.
DRC (Dynamic Range Off
Control)
On
Auto
• This affects such audio signals as Dolby Digital, Dolby TrueHD, and Dolby Digital Plus.
• DRC affects audio signals output from the following audio output terminals:
– Analog audio signals output from the AUDIO OUT terminals
– Linear PCM audio signals output from the DIGITAL OUT or HDMI OUT terminals
• Depending on the disc, the effect may be weak.
• The effect may differ depending on the speakers, the AV amplifier settings, etc.
Explanation
Select this to output digital audio signals directly.
Select this to output digital audio signals converted to 2-channel
audio signals.
When a BD containing secondary audio and interactive audio is
played, the two audio signals are mixed and converted to Dolby
Digital audio or DTS audio for output.
Select this to output audio signals other than digital audio signals.
Surround audio signals converted to linear PCM audio signals are
converted into 2-channel (stereo) signals for output.
Surround for output (when the connected AV receiver or amplifier,
etc., is compatible with Dolby Pro Logic, the AV receiver or amplifier
outputs the linear PCM audio signals as surround audio signals).
Outputs audio signals that are limited to a sampling frequency
below the set sampling frequency from the DIGITAL OUT terminal.
Select according to the performance of the connected device.
Select this to output audio signals without using the DRC function.
Select this to adjust the range between the loudest and softest
sounds (dynamic range) for playback at average volume. Use this
when it is hard to hear dialog or when watching movies at midnight.
Select to switch the DRC setting On/Off automatically according to
the input audio signal from the disc. This only affects Dolby TrueHD
signals.
07
41
En