Basic Functions - Trevi XF 3400 PRO Mode D'emploi Et Branchement

ENGLISH
Installing the Batteries
Remove the battery cover from the Remote Control and put 2xAAA size batteries inside the compartment. The diagram inside the
Battery Compartment shows the correct way to install the batteries.
TRANSPORTATION
For transportation, use the upper handle, slightly fold the appliance and use the two rear wheels.
POWER
This unit works with rechargeable lead-acid 12V
When the battery is low or the device does not turn on, turn the main POWER switch (22) to the "OFF" position, connect the power
supply cable to the socket (20) on the device and plug into a power outlet to recharge.
States of the signaling LED indicator light Battery charging:
- LED indicator BLUE: the device is connected with the adaptor and battery is being charged.
- LED indicator GREEN: Charging finished, the battery is charged.
- LED indicator RED: Battery is low.
Caution: Do not connect the appliance to sockets with a voltage other than that indicated.

BASIC FUNCTIONS

POWER ON/OFF
- Set the POWER switch (22) to "BAT" - "I" to turn on and use the device with its internal battery.
- Set the POWER switch (22) to "OFF" - "0" to completely switch off the device.
- Set the POWER switch (22) to "DC" - "II" to turn on and use the device with DC adapter.
BATTERY CHARGE
- Set the POWER switch (22) to "OFF" - "0" to recharge the battery; the charging function and the LED indicating charging
status will start immediatly.
For a longer battery life it is recommended to disconnect the mains power cable after 10 hours max of recharging.
STAND-BY
You can switch the system to standby mode using the button
Press it again to Switch On the unit.
Caution:
- In standby mode the battery is NOT recharged and the device has a minimum battery consumption.
- The Stand-by function works only when the main POWER ON/OFF switch (22) is in position "I" or "II".
- In stand-by function there is no LED indicating.
- For long periods of inactivity it is necessary to disconnect the mains cable and recharge the battery periodically.
MODE SETTING FUNCTION
To change the mode function, press more 'times the MODE key (6) on the unit or press M button (24) on remote control to select:
BLUETOOTH (the display BLUE), USB/SD (only if the USB socket (15)/Micro SD (14) is connected to a memory, the display shows
for a few seconds "USB" or "SD"), AUX-IN (the display shows "LINE").
ADJUSTING THE VOLUME
1. Turn the Main Volume control (7) to increase or decrease the overall volume of playback, or use the buttons (40) and (43) on
the remote control;
2. Press the MIC button (13) and turn the knob (7) to adjust the volume of the signal on the MIC1 and MIC2 inputs. The regulation
acts on the two inputs simultaneously.
9A and with power adapter 20V
(46) on remote control;
13
XF 3400 PRO
4A.