Geberit Mapress 2 Mode D'emploi page 37

Operating instructions for Mapress pressing collar and adapter for pressing collar
5
Slide the locking lug over the locking pin until it snaps into place
(position 1) and the pressing collar firmly surrounds the fitting
6
Turn the pressing collar into the pressing position
7 Make sure that the release lever and locking lug form a line
Hooking the adapter for pressing collar ZB 221 / 321 into the
pressing collar (ø 108 mm)
Prerequisites
Pressing collar is positioned. Locking pin is in position 1.
WARNING
Risk of injury caused by flying fragments if adapter for
pressing collar is used incorrectly
Make sure that the claws of the adapter for pressing collar
always completely embrace the pins of the pressing collar
Repeat the pressing operation if a position of the locking pin is not
reached during the pressing operation or the pressing sequence is
interrupted. See also operating instructions of pressing tool.
1
To open the adapter for pressing collar, push both jaw levers
together (1)
EN
37