OPERATING INSTRUCTIONS (continued)
SETUP MENU (continued)
Selected characters
Auto Tuning
Country
Search
Manual Tuning
Position
Search
(C--)
(S--)
(--MHz)
Descrambler
Name
Sound System
Colour System
Skip
NR
Fine Tuning
Sort
(Position list
designated rows)
Auto Off
[During VIDEO signal input]
1 item is added to the Menu shown in the page
Selected characters
Scart Output
52
(Page1)
(Page2)
–
1
2
3
••••••
–
–
–
–
Off
( :a letter)
BG
I
L'
Auto
PAL
NTSC3.58
Off
Off
Decreasing the frequency
Increasing the frequency
data for the main tuner
data for the main tuner.
–
Off
39
TV
Monitor
Select the country name using the M L SELECT buttons and press
OK button.
(Page3)
• If some required stations could not be preset using the auto tuning
function, select and preset the required station in the required
position using the manual tuning operation.
–
Press the OK button and it starts the auto tuning.
Set the position number. This also can be set by M L PROGRAM
199
AV00
UP/DOWN buttons.
Select the channel entry method. Enter a two digit channel number
–
(CH), a two digit S-band number, or a 3 digit frequency (MHz).
Use the 0-9 NUMBER buttons to enter a two digit number. If the number
–
is a standard channel number, the unit begins searching for the channel.
Use the 0-9 NUMBER buttons to enter a two digit number. If the number
–
is a standard S-band number, the unit begins searching for the channel.
Use the 0-9 NUMBER buttons to enter a three digit number. If the number
–
is a standard frequency, the unit begins searching for the channel.
Set this to Off normally. If it is set to On, the AV4 (Scart) terminal
On
operates as TV signal input, and the screen changes to display AV4
(Scart) input signal automatically.
This is used to input a 5 digit name for a TV station. After fixing the
cursor on the first digit, select a letter by M L SELECT buttons and
move to the next digit by
again when finished.
• Selectable letters are "0"~`"9", "A"~`"Z", "+", "–", " "(blank),
","(comma) and "."(period) .
DK
Select one of 5 different settings for the sound system.
L
SECAM
Select one of 5 different settings for the colour system.
NTSC4.43
If this is set to On, the selected position will be skipped while
On
selecting positions by PROGRAM UP/DOWN buttons.
This is automatically set to On for non-broadcasting channels.
If this is set to On, it helps to reduce the noise interference visible on
On
the screen, especially in weaker signal reception areas.
After completing fine-tuning, press the RETURN button to exit this
mode.
• The variable range is -56 ~ +56.
Move the cursor to the row of the channel you wish to change, and press
the OK button. The display characters change to green. Use the M L
–
SELECT buttons to move the row to the disired location, and press the
OK button when you have finished. Press the RETURN button to exit.
If this is set to On, the power will be turned off when there is no
On
transmission signal and no operation for about 10 minutes in the TV
mode.
.
TV:AV4 (Scart) output will be fixed as TV signal output.
Monitor:AV4 (Scart) output can view the same image as displayed on
the main unit. It is possible to monitor only the composite video signal
from AV1, AV2, or AV3 input that is displayed on the screen at the time.
• If Descrambler is set to On, it will be fixed as TV automatically.
Setup hint
ADJUST button. Press the OK button
Setup hint