Size Switching; Input Signal Screen Display - Yamaha PDM-4210E Manuel Utilisateur

OPERATING INSTRUCTIONS (continued)

Size Switching

Each time the SIZE button of the remote control or the monitor is pressed, the screen display area will change in
sequence and the status will be displayed at the bottom of the screen.
* Real mode gives an image of the same shape as it is displayed on a computer monitor.
This mode is only available for VGA (640 X 480) and WVGA (864 X 480).
Display area selection diagram (RGB input)
Resolution Full display
Display Full
640 X 480
(VGA)
800 X 600
(SVGA)
1024 X 768
(XGA)
1280 X 1024
(SXGA)
1600 X 1200
(UXGA)
Processes such as compression (thinning) and expansion are performed for the above signal display. Because of this, there is a possibility that
flicker may become noticeable on Zoom (1 ~ 3) depending on the display contents. If this occurs, turning the Vertical Filter On
the flicker.

Input Signal Screen Display

The input signal status can be displayed on the screen by pressing the RECALL button of the remote control or the
monitor.
• The display will go out in approximately 6 seconds.
RGB
Off-timer
On-timer
RECALL button
SIZE button
Normal
*
Real Zoom3
Normal Real
* VGA and W-VGA
only
-- -- Min.
OFF
-- -- : -- --
RGB 1 RGB 2
AV1 AV2
AUTO PinP
MENU
SIZE button
ID
Full Zoom1
Zoom2
Circular display
Zoom1
Input mode
RGB2
RGB
Signal mode
H : 48.4kHz
Input horizontal frequency
V : 60.1 Hz
Input vertical frequency
MUTE VOL
AV3 AV4
SIZE RECALL
RECALL button
OK
ID SET
Zoom2 Zoom3
can reduce
20
15