Colour System; Video Input - Yamaha PDM-4210E Manuel Utilisateur

OPERATING INSTRUCTIONS (continued)
SETUP MENU
MENU
Selected characters
System

Colour System

AV1
AV2
AV3
AV4

Video Input

AV1
AV2 (1st step)
AV2 (2nd step)
AV4
38
Picture
Audio
Timer
Function
Setup
Language
Select
OK Set
System1 System2
Auto PAL SECAM
NTSC3.58 NTSC4.43
Auto HDTV SDTV/DVD
RGB Composite/Component
Auto HDTV SDTV/DVD
S.Video Composite
Setup
System System 1
OK
Colour System
Video Input
Audio Input
Scart Output Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select OK Set Return
Setup
System System 1
Colour System
Video Input
Audio Input
Scart Output Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select OK Set Return
Setup
System System 1
Colour System
Video Input
Audio Input
Scart Output Monitor
RGB1 DVI-STB
RGB2 Component
HDTV
Select OK Set Return
Do not change the original setting.
(System1 : Europe/Asia, System2 : North America)
This should correspond to the colour system of the signal from the
equipment that is connected to the AV1 video input terminal.
• Normally, set this to Auto. The system of the input signal will be
automatically recognized.
• If the input signal contains a lot of noise or has a low level at Auto and
the operation is erratic, set this to match the input signal.
• When the component signal is received, this setting is not available
(grayed out).
(Same to AV1)
This should correspond to the signal mode of the signal from the
equipment that is connected to AV1 video input terminal.
• Normally, set this to Auto. The signal mode of the input signal will be
automatically recognized.
• If the input signal contains a lot of noise or has a low level at Auto and
the operation is erratic, set this to match the input signal.
This should correspond to the signal mode of the signal from the
equipment that is connected to AV2 video input terminal.
This step should be set only when [Composite/Component] is selected on
the 1st step. The procedure is same as for AV1.
• If the signal from the equipment that is connected to the AV4 Scart input
terminal is S.Video or Composite, set this to correspond to that signal.
• If the signal is RGB, it will be automatically recognized and this setting
will have no effect.
Setup
Colour System
OK
AV1 Auto
AV2 PAL
AV3 SECAM
AV4 PAL
Select Return
Setup
Video Input
OK
AV1 Auto
AV2 Composite/Component
AV3 Auto
AV4 S.Video
Select Return
Setup
Audio Input
OK AV1 Stereo
AV2 L/Mono
AV3 Stereo
AV4 L/Mono
Select Return
Setup hint
Exit
Exit
Exit