Dometic 8882040004 Instructions De Montage page 29

Mounting the drive unit
A
CAUTION!
For safety reasons when drilling, note the location of existing wiring harness-
es, wires and other components, in particular those which are not visible The
respective components are to be fitted so as not to create a risk of injury for
vehicle occupants (e.g. due to sharp edges) and not to impair the function of
safety features!
➤ Drill where shown in
the picture opposite.
➤ Remove the two guide rails for the tool box.
➤ Cut open the carpet in the area around the rubber dampers.
➤ Drill through-holes for hose lines on the underside of the rear wall.
➤ Drill an additional through-hole in the load area.
Frigo
29