GreenWorks Tools 2502107 Mode D'emploi page 8

EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
Problem
Handle is not in position.
Mower is not starting.
Mower is cutting grass unevenly.
Mower is not mulching properly.
Mower is hard to push.
Mower is not bagging properly.
Mower is vibrating at higher speed.
Motor stops while cutting.
If these solutions do not solve the problem contact your authorised service dealer.
English (Original Instructions)
TROUBLESHOOTING
Possible cause
Carriage bolts are not seated
properly.
Battery is low in charge.
Battery is either inoperable or will
not take a charge.
The battery key is not inserted.
Lawn is rough or uneven or
cutting height not set properly.
Wet grass clippings are sticking to
the underside of the deck.
High grass,
housing and blade are dragging
in heavy grass, or cutting height
too low.
Cutting height is set too low.
Blade is unbalanced, excessively
or unevenly worn.
Motor shaft is bent.
Cutting height is set too low.
Battery has no power.
Adjust the height of the handle and
make sure the carriage bolts are
seated properly.
Charge the battery.
Replace the battery.
Insert the battery key.
Move the wheels to a higher
position. All wheels must be placed
in the same cutting height for the
mower to cut evenly.
Wait until the grass dries before
mowing.
rear of mower
Raise the cutting height.
Raise the cutting height.
Replace the blade.
Stop the motor, remove isolator key
and battery, disconnect the power
source, and inspect for damage.
Have it repaired by an authorised
service center before restarting.
Raise the cutting height.
Charge the battery.
7
Solution