Assembling The Cutting Equipment; Fitting The Trimmer Guard And Trimmer Head - McCulloch T26CS Manuel D'utilisation

S1156009-38,T26CS_1.fm Page 11 Wednesday, April 6, 2016 1:15 PM
Assembling the cutting
equipment
WARNING! Never use a cutting
!
attachment without an approved guard.
See the chapter on Technical data. If an
incorrect or faulty guard is fitted this can
cause serious personal injury.
Fitting the trimmer guard and
trimmer head
• Fit the guard as shown in the diagram. Tighten
securely.
• Fit the dust cup on the shaft. The nut must be
completely covered by the dust cup.
• Hold the dust cup with a spanner to prevent the shaft
from rotating.
• Screw the trimmer head onto the shaft.
ASSEMBLY
–
English 11