SilverCrest SGB 1380 B2 Mode D'emploi page 10

- With the time switch 5 set the pre-heat time
(ca. 10 minutes).
- Close the glass door.
When the warm-up period is finished, place
the foodstuffs on the roasting grill 7 resp. the
baking tray 8 and slide it in on one of the
rails 6 . Ensure that there is sufficient space
between the foodstuffs and the inner walls/
heating elements of the appliance.
Attention!
NEVER place objects, food, bowls, the baking tray 8 ,
the roasting grille 7 or other containers directly
on the bottom of the oven! The resulting heat accu-
mulation will damage the appliance! ALWAYS place
food, bowls or other containers on the baking tray 8
or the roasting grille 7 , and slide these into one of
the 3 rails 6 .
If you wish to prepare food on the roasting grill 7
that drips excessively, then slide the baking tray 8
into the bottom rail. By doing this, dripping fat
for example will be caught and the appliance
is then easier to clean.
The most uniform baking results are obtained
when the baking tray 8 resp. the roasting grill 7
are placed on the central runner and the air
circulation is switched on.
Close the glass door before starting the grill or
baking process.
If you are cooking especially fatty foodstuffs,
an increased smoke development can occur.
In this case, do not close the glass door comple-
tely, instead, allow it to be slightly open: If you
carefully push the door to, it comes into this
position shortly before closing.
Adjust the time switch 5 to the required gril-
ling or baking time.
The maximum grilling or baking time is 60 minutes.
If the cooking time for the foodstuff amounts to
less than 25 minutes, first of all place the time
switch 5 at 60 minutes and then turn it back
to the required grilling or baking time.
The control lamp 1 indicates that your Oven with
Grill is switched on. The switch of the time switch 5
now rotates itself anti-clockwise towards OFF.
When your Oven with Grill has reached the set
temperature, the heating elements switch them-
selves off at intervals, to ensure that the tempe-
rature is maintained.
The appliance switches itself off automatically
on completion of the programmed time. If you
wish to switch the appliance off prematurely,
turn the time switch 5 back to OFF. Place the
function switch 3 at the position OFF and re-
move the plug from the power socket.
You will hear a signal sound and the control lamp 1
extinguishes.
After the appliance has switched itself off, the
time switch 5 can continue to run for a short
period.
- 7 -