Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Rafter cut (with bevel)
•
Measure the required cut-out on the object and
transfer this to the foam board.
•
Loosen the screws for wire adjustment (2 x No.
6) and arrange the wire in a diagonal position so
that the slope is aligned parallel to the line trans-
ferred to the foam board.
•
Then re-tighten the screws for wire adjustment
(2 x No. 6).
•
Tauten the wire by unscrewing the screw for the
wire tightener (No. 5), then pull this upwards un-
til the wire is sufficiently taut and then re-tighten
the screw again.
•
Position the foam board on the bearing rail (No.
4).
•
Unscrew the locking screw on the corner cutter
and guide the corner cutter downwards using the
manual guide (No. 3).
•
Cut into the foam board with the corner cutter
until you reach the end of the marked point.
•
Then remove the foam board to the left using
your left hand.
•
If you have reached the marked point of the foam
board, raise the corner cutter again using the ma-
nual guide (No. 3).
Rafter cut
Cut-outs (complete)
•
Position the foam board on the bearing rail (No.
4).
•
Use the manual guide (No. 3) to shift the manu-
al cutter downwards until you reach the desired
point for the incision into the board.
•
Slide the foam board from left to right until you
have reached the desired length for the cut-out.
•
Raise the corner cutter again using the manual
guide (No. 3) until you have reached the desired
height for the cut-out.
•
Now slide the foam board from right to left until
you have reached the desired length.
•
Now guide the corner cutter back to the starting
point using the manual guide (No. 3).
Cut-outs
only possible with an incision
40
Publicité
Table des Matières
