Leica Microsystems FS C Manuel D'utilisation page 37

Shotgun shell casing holder
The shotgun shell casing holder (42.1) has three
spring rods rounded at the edges (42.2), to
which shotgun shell casings (43.1) of various
calibers can be attached. The conical base
(43.2) is provided for centering the shell casings.
Fig. 42 Adjustable holder with shotgun shell casing holder
1 Shotgun shell casing holder
2 Spring rods
Fig. 43 Adjustable holder with shotgun shell casing holder
1 Shotgun shell casing
2 Conical base
Wire holder
In the wire holder (44.1), round parts between
0.6 mm and 8 mm in diameter can be clamped in
order to (for example) examine cutting marks.
Receptacles for locking cylinders
Using an underlay of plasticine, these recepta-
cles (45.1) can be used to securely fasten lock
cylinders of safety locks bearing toolmarks.
Fig. 44
1 Wire holder
2
1
Fig. 45
1 Receptacle for locking cylinder
2
1
Adjustable holder with wire holder
1
Adjustable holder with receptacle for locking cylinders
1
9. Accessories
37