Leica Microsystems FS C Manuel D'utilisation page 17

Transmitted Light
The transmitted illuminator is pre-installed in the
factory.
• Screw the light guide with ø 9 mm (Fig. 12)
onto the cold light illuminator (8.1).
• Place the cold light source next to the stand
or onto the shelf that is to be screwed onto
the base of the comparison macroscope (7.1).
Fig. 12 Light guide ø 9 mm
Fig. 13 Transmitted light illuminator
1 Connection for light guide
1
• Insert the two light guide ends into the left and
right receptacles on the transmitted light illu-
minator (13.1).
• Connect the cables of the transmitted light il-
luminator on both sides with the rear side of
the stand (17.2, 17.3).
UV Illumination
• Screw the holder for UV lamps (14.1) onto the
comparison bridge.
• Insert the UV lamps (14.3) into this holder.
Align them with the object and screw them
tight.
Fig. 14 Assembly of the UV illuminator
1 Holder for UV lamps
2 Rod for fastening a UV lamp
3 UV lamp
7. Assembly
1
2
3
17