Güde 400/40-5.0S Traduction Du Mode D'emploi D'origine page 28

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 31
ENGLISH
24
Before using, always visually inspect to see that
the blades, blade bolts and cutter assembly are not
blunt, worn or damaged. Replace worn or damaged
blades and bolts in sets to preserve balance;
The protective equipment on the appliance is
strictly prohibited to be disassembled, changed,
used in conflict with the designation and it is
prohibited to attach any protective equipment of
other manufacturers.
The appliance must not be used if damaged or
safety equipment is defective. Replace any worn-out
and damaged parts.
Do not start the engine before your feet are in a safe
distance from the cutting tools.
Do not incline the appliance when being started.
Do not start the appliance when you are standing in
front of the ejection opening.
Do not race when working with the appliance. Walk
slowly and cautiously.
Be careful when going backwards – risk of tripping!
Make sure your posture is safe, especially on slopes. Do
not cut on too steep slopes. Be particularly careful when
changing travelling direction on slopes.
On slopes always go straight to the slope and not up
and down.
Pay maximum attention when turning around and
pulling the appliance to you.
Switch the mower off whenever carrying or inclining it
or when being outside a grass area. Wait until all rotating
parts have stopped.
If an undesirable item is encountered or the appliance
starts vibrating, the appliance must be switched off and
the socket plug removed. Check whether the appliance
is not damaged. Repair any damage.
Switch the appliance immediately off after finishing
your work.
• Stop the machine and take out the contact key. Wait
until all rotating parts have stopped and the unit has
cooled down. Take out the key.whenever you leave
the lawnmower.
• To release a blocked blade.
• To adjust the mowing height.
• To empty the collection bag.
• Check the machine if working perfectly after catching
an undesirable object. Repairs must be executed
before putting the machine into operation again..
• To lift the machine or take it away..
• To flip the mower over or carry it (e.g. from lawn to
lawn or across a road).
• Clean the mower or do any other works before
checking the mower.
The ON/OFF switch and safety switch must not be
locked.
Use only those batteries for the power tool that have
been designed to be used for that tool. Use of other
batteries may lead to injuries and a risk of fire..
Avertissement: Cet outil électrique génère pendant
le fonctionnement un champ magnétique. Dans
certaines circonstances, ce champ peut perturber
le fonctionnement des implants médicaux actifs ou
passifs. Afin de réduire le risque de blessure graves
ou mortelles, nous recommandons aux personnes
portant un implant médical de consulter un médecin
et le fabricant de l'implant médical avant l'utilisation
de l'appareil.
Do not use the device near flammable liquids or
gases. Risk of fire and explosion in case of short
circuit.
Battery
Risk of fire! Risk of explosion!
Never use damaged, defective or deformed accu-
mulators. Never open or damage the accumulator
or let it fall on the ground.
Protect the battery against heat and fire.
Battery to be used at the ambient temperatures
between 10°C and +40°C only.
Never put the battery on heaters and do not
expose it to strong sunlight for a long time.
After being subject to heavy load, let the battery
cool down first.
Short circuit - do not bridge the accumulator
contacts with metal parts.
The accumulator must be packaged (plastic bag,
box) or accumulator contacts must be sealed up
for accumulator disposal, transport or storage.
The Güde charger to be used only to charge the
battery. There can be malfunction or fire if different
chargers are used.
Vapours may leak out in case of unauthorised use or
when using a damaged accumulator. Bring fresh air
and seek medical advice if experiencing difficulties.
Vapours may irritate the respiratory system.
Work instructions
Accumulators are supplied partially charged and must
therefore be fully charged before being used for the
first time.
Charge the accumulator when the appliance is run-
ning slowly or stops.
A li-ion battery may be charged at any time without
any shortening of its life. Charging process interrupti-
on will not damage the accumulator.

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

95881

Table des Matières