Fitting - ETNA T380ZT Mode D'emploi

INSTALLATION

Fitting

EN 20
Operate appliance on 1 phase
If your home installation is not fitted with 23 Amp fuses, the appliance's
total power consumption can be limited (power limiter) so that the
power consumption doesn't rise above 16 Amp. Not all zones can be
used at full power if the power limiter is activated. The appliance will
beep and the display will flash the set power when the maximum power
consumption has been reached.
Setting
• Within 2 minutes of connecting the appliance to the electric power
press all 4 cooking zone selection buttons simultaneously. Keep
these pressed down for at least 3 seconds.
• 'Hi' will appear in the display.
• Push the '-' or '+' button and select 'Lo' in the display.
• Again press all 4 cooking zone selection buttons and keep these
pressed for at least 3 seconds.
• Check that the cabinet and the cut-out meet dimension and
ventilation requirements.
• Treat the sawn ends of wooden or synthetic worktops with sealing
varnish if necessary, to prevent moisture causing the worktop to swell.
• Lay the hob upside down on the worktop.
• Fit the connecting cable to the appliance in compliance with
requirements.
• Remove the protective layer from the sealing tape and apply the
tape in the groove of the aluminium profile or on the edge of the
glass plate. Do not stick the tape around the corners, but cut
4 separate pieces to seal the corners well.