ETNA T380ZT Mode D'emploi page 31

OPERATION
Select the desired function:
1. Cooking-timer — the timer is linked to a cooking zone. After the
set time has elapsed, the cooking zone will switch off automatically.
2. Alarm — the alarm only beeps after the set time has elapsed.
The alarm works in the same way as the cooking-timer, but is not linked
to a cooking zone. If the alarm has been set, it will continue running
after the hob has been switched off. The alarm can only be switched off
when the hob is switched on.
Switching on the cooking-timer, activating and switching off
• Press simultaneously the – and + button (E).
▷ If you have switched on a cooking zone (C) prior to this, the
accompanying display will be brighter. The cooking-timer that
you have now set applies to this cooking zone. The decimal
point next to the power level means that the time has been
activated for this zone.
▷ The alarm can also be activated without a cooking zone being
selected. Two flashing decimal points indicate that the alarm is
counting down.
• Set the cooking time using the – or + button (E). (When you press
'-', the time will be set for 30 minutes. If you keep the button
pressed the time will run faster).
• The time can be set to a value between 01 and 99 minutes. The
cooking-timer can be set for each cooking zone.
• Check the remaining time by selecting the cooking zone concerned
(C) while simultaneously pressing the - and + button (E). Adjust the
cooking time using the – or + button (E).
• After the set time has ended the '00' will flash in the display, as well
as the timer's decimal point. Furthermore you will hear a repeated
short beep. Switch off the timer and alarm signal by pressing
a random button. If you don't do this, the signal will switch off
automatically after three minutes.
EN 11