Clean The Dust Collector And Filters; Clean The Rolling Brush - EUFY RoboVac T2108 Manuel D'utilisation

English

Clean the Dust Collector and Filters

Press the dust collector release button to pull the dust collector out.
Open and empty the dust collector.
1
Remove the pre-filter by pulling the hooks as shown.
Take out the foam filter and high-performance filter.
Clean the dust collector and filters with a vacuum cleaner or a cleaning brush.
Put the filters and pre-filter back together in the dust collector.
18
2
Push the dust collector back into the main unit.
You can wash the dust collector, pre-filter and foam filter with water. Be sure to
air-dry them thoroughly before reassembling. Do not wash the high-performance
filter with water, as it may damage the filter and reduce the suction power.

Clean the Rolling Brush

Pull on the release tabs to unlock the brush guard as shown.
Lift the rolling brush to remove.
Clean the rolling brush with the provided cleaning tool or a vacuum cleaner.
Reinstall the rolling brush by inserting the fixed protruding end first and then clicking
into place.
Press down to snap the brush guard into place.
1 2
4 5
English
3
19