Electrical Installation - Asko T756HP Instructions D'installation

Condensed water
The machine is supplied as shown in Option 1
(inset). This means that the condensed water
is pumped into the condensed water container.
This must then be removed and emptied by
hand.
Option 2 allows you to remove the small short
hose from the nipple. Attach the rubber hose
supplied to the same nipple. The water can
then be pumped out into a sink or a fl oor drain
(2a).
2
1
2a

Electrical installation

• The electrical wall socket must be placed
outside of the installation area to be easily
accessible.
• The machine must only be connected to an
earthed wall socket.
• Any residual current devices must be type
A.
Connection on delivery
Information about the electrical connection
can be found on the type plate. Compare the
data with the mains supply data.
Transport/Winter storage
The machine must be transported upright!
Leave the machine to stand for 24 hours after
transporting. If you need to move your ma-
chine or store it over the winter in unheated
premises, make sure that you drain the
condensed water container beforehand.
Type plate
English
13