Electrical Installation - Asko T784C Instructions D'installation

English

Electrical installation

• The electrical wall socket must be placed
outside of the installation area to be easily
accessible.
• The machine must only be connected to an
earthed wall socket.
• Any residual current devices must be type
A.
Connection on delivery
Information about the electrical connection
can be found on the type plate. Compare the
data with the mains supply data.
14
Switch-over
It is possible to switch between 10A (heat output 1950W) and 16A (heat output 2500W). The
switchover must be performed by a qualifi ed electrician. Below we describe how to do this for
each model.
LINE SERIES™-CLASSIC
1. Turn off the machine using the main power
switch.
2. Press and hold the "Temperature button"
and then switch on the Main power
Type plate
switch.
3. If the upper right LED by the programme
selector and the LED by the "Temperature"
button
for 10A and 1950W. If both the upper
and lower right LEDs by the programme
selector and the LED by the "Temperature"
button
16A and 2500W. Press the "Anti crease"
button
4. Press the Stop button to save.
1. Turn off the machine using the main power
switch.
2. Press and hold the "Anti crease button"
and then switch on the Main power
2h
switch.
3. If the upper right LED by the programme
selector and the LED by the "Anti crease"
button
set for 10A and 1950W. If both the upper
and lower right LEDs by the programme
selector and the LED by the "Anti crease"
button
for 16A and 2500W. Press the "Time saver"
button
4. Press the Stop button to save.
LINE SERIES™-LOGIC
1. Turn off the machine using the main power
switch.
2. Press and hold the "Temperature button"
and then switch on the Main power
switch.
3. Turn the programme selector and choose
between "Heater 2 On" (2500W/16A) and
"Heater 2 Off" (1950W/10A).
4. Press the Start button once to save your
selection. The machine returns to the
programme menu.
are lit then the machine is set
are lit then the machine is set for
once to switch the heat output.
2h
2h are lit then the machine is
2h are lit then the machine is set
once to switch the heat output.
LINE SERIES™-STYLE
Fully built-in machine
1. Turn off the machine using the main power
switch.
2. Press the Stop button and switch on the
machine with the Main power switch. Then
press the Stop button 5 times within 10
seconds.
3. Press the up or down arrow button
and choose between "Heater 2 On"
(2500W/16A) and "Heater 2 Off"
(1950W/10A).
4. Press the Start button once to save your
selection. The machine returns to the
programme menu.
Standard machine
1. Turn off the machine using the main power
switch.
2. Press the Stop button and switch on the
machine with the Main power switch. Then
press the Stop button 5 times within 10
seconds.
3. Turn the programme selector and choose
between "Heater 2 On" (2500W/16A) and
"Heater 2 Off" (1950W/10A).
4. Press the Start button once to save your
selection. The machine returns to the
programme menu.