Pre-Operation Inspection; Tool And Work Area Set-Up - RIDGID micro CA-25 Manuel De L'opérateur

micro CA-25 Inspection Camera
Figure 5 – Installing Accessories
Pre-Operation
Inspection
WARNING
Before each use, inspect your inspec-
tion camera and correct any problems
to reduce the risk of serious injury from
electric shock and other causes and
prevent tool damage.
1. Make sure the unit is OFF.
2. Remove the battery holder and inspect it
and batteries for signs of dam age. Re -
place batteries if necessary. Do not use
inspection camera if batteries are dam-
aged.
3. Clean any oil, grease or dirt from the e -
quip ment. This aids inspection and helps
prevent the tool from slipping from your
grip.
4. Inspect micro CA-25 Inspection Camera
for any broken, warn, miss ing, misaligned
or binding parts or any condition which
may prevent safe and normal operation.
5. Inspect the camera head lens for con-
densation. To avoid damaging the unit, do
not use the camera if condensation forms
inside the lens. Let the water evaporate
before using.
6. Inspect the full length of the cable for
cracks or damage. A damaged cable
could allow water to enter the unit and in-
crease the risk of electrical shock.
7. Check that the warning label is present,
firmly attached and readable.
6
Accessory
Figure 6 – Warning Label
8. If any issues are found during the in-
9. With dry hands, re-install the battery hold -
10. Press and Hold the Power Button for 1
11. Press and Hold the Power Button for 1
Tool and Work Area
Set-Up
Set up the micro CA-25 In spec tion Cam -
era and work area according to these
procedures to reduce the risk of injury
from electrical shock, entanglement and
other causes and prevent tool and sys-
tem damage.
1. Check work area for:
spection, do not use the inspection cam-
era until it has been properly serviced.
er, making sure to fully insert.
second. Once the camera is ready an
image will appear. If the unit does not
operate properly, try changing the batter-
ies.
second to turn the unit OFF.
WARNING
• Adequate lighting
• Flammable liquids, vapors or dust that
may ignite. If present, do not work in
area until sources have been identified
and corrected. The micro CA-25 In -
spection Camera is not explosion proof
and can cause sparks.