Special Programs: Melt, Simmer, Power Boost, Automatic Warm-Up - Foster 7334/945 Manuel D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

using the cooktop
appear on all displays to confirm your selection and the relative led will light up.
When the Child safety lock is enabled you can switch the appliance off. The
Child safety lock is still enabled when the appliance is switched on again.
To unlock the appliance permanently, press simoultaneously the Control lock
key and the Pause/Recall key , then again the Pause/Recall key. In this case
the Child safety lock won't be enabled when the appliance is switched on
again.
To unlock the appliance temporarily press simoultaneously the Control lock
key and the Pause/Recall key. In this case the Child safety lock will still be
active each time the appliance is switched on again.
Special programs: Melt, Simmer, Power Boost, Automatic
warm-up
The cooktop has three special programs that have already been set to perform
special cooking operations.
• Melt
The ''Melt'' program sets the heat temperature of the selected cooking zone
at 70°C/158°F to melt chocolate, butter or the like. To activate this program
press the slidebar in correspondence of the symbol ''Melt-Simmer".
• Simmer
The ''Simmer'' program sets the heat temperature of the selected cooking
zone at 94°C/201,2°F to bring to a boil slowly preparing sauces or soups
and stews. To activate this program press the slidebar in correspondence of
the symbol ''Melt-Simmer", then press again and hold on until the Simmer
symbol lights up besides the cooking zone display.
• Power Boost
This program further reduces the cooking time of a certain cooking zone, by
bringing the temperature to the maximum heat level for 10 minutes.
At the end of this timeframe, the cooking zone heat level will automatically go
back to level "9". The use of this function is recommended for heating large
quantities of liquids (e.g. water to cook pasta) or food in a very short time.
To activate this program, switch on your cooking zone and slide right on the
slidebar until you reach level ''9'' then press the Power boost key. An acoustic
signal will be heard, and the ''P'' symbol will be shown on the cooking zone
display.
• Automatic warm-up
All cooking zones are equipped with an automatic warm up function. This
feature sets the cooking zone to the highest heat level for a certain period of
time and then automatically switches back to the cooking setting that was
14

Publicité

Table des Matières
loading

Table des Matières