Power Boost; Timer; Egg Timer/Reminder - Foster 7322/300 Manuel D'installation Et D'utilisation

using the cooktop

Power Boost

The use of this function is recommended for heating large quantities of liquids
(e.g. water to cook pasta) or food in a very short time.
This program further reduces the cooking time of a certain cooking zone, by
bringing the temperature to the maximum heat level for 10 minutes.
At the end of this timeframe, the cooking zone heat level will automatically go
back to level "9". To activate this program, switch on the cooking zone and
press the [+] key until you reach level ''9'' then press the [+] key again. The ''P''
symbol will be shown on the cooking zone display to confirm the activation of
the function.

Timer

This function allows you to set the time from ''01''(1 minute) to ''99'' (99 minutes)
for the automatic switch off of a cooking zone.
Select a cooking zone by pressing the corresponding Zone Selection key and
adjust the heat level. Press simultaneously the [+] and [-] keys to activate the
Timer display. Set the desired time within 10 seconds using the [+] and [-]
keys. Wait 10 seconds for the automatic confirmation of the settings. The time
countdown will be shown on the timer display.
When time elapses the cooking zone will automatically switch off, the display will
show a flashing ''00'' and an acoustic signal will be heard. Press any key on the
control panel to stop the signals.
To disable the timer of a cooking zone press the corresponding Zone Selection
key then press simoultaneously the [+] and [-] keys to turn on the Timer display.
Bring the timer value back to ''00'' by using the [-] key. Wait 10 seconds for
the automatic confirmation.The led on the display of the cooking zone stops
flashing.

Egg timer/reminder

When no cooking zone is active it is possible to set an acoustic reminder which
stays active after switching the appliance off. When the Egg timer/Reminder
function is active, the Timer function cannot be selected.
To enable this function switch on the appliance then press simoultaneously
the [+] and [-] keys. The timer display lights up. Set the time, ranging from
''01''(1 minute) to ''99'' (99 minutes), by pressing the [+] and [-] keys. Wait 10
seconds for the automatic confirmation of the settings. The time countdown will
be shown on the timer display.
When time elapses the display will show a flashing ''00'' and an acoustic signal
will be heard. Press any key on the control panel to stop the signals.
10