Electrical Components; Alarm Management - Anselmo Cola AMBRA Manuel D'installation, D'utilisation Et D'entretien

6.3 Stove internal parts

6.4 Electrical components

7 TROUBLESHOOTING

7.1 Alarm management

Alarms are indicated by an acoustic signal (if activated) and a message on the control panel.
In case of an alarm the shutdown procedure is automatically activated. Cancel the signalling by pressing button P4
and wait until the stove reaches OFF status. Eliminate the cause and restart the stove according to the normal
procedure described in this manual.
Listed below are the alarms that can appear on the control panel, with the causes and cures:
Key:
1 - Combustion chamber
2 - Support boundary
3 - Cast iron exchanger
4 - Vermiculite side walls
5 - Vermiculite upper baffle
6 - Vermiculite rear wall
Key:
1 - Electronic board O100
2 - Safety thermostat
3 - Room probe
4 - Control and safety vacuum switch
5 - Fume probe
6 -Gearmotor
7 – Fume extractor
8- Rear tangential fan
11- Control panel mod.N032
41 AMBRA