Remote Control - Anselmo Cola AMBRA Manuel D'installation, D'utilisation Et D'entretien

4.6.4 Menu 04 – select language
With this selection it is possible to set the desired language from those available.
4.6.5 Menu 05 – standby mode
By selecting ON in STANDBY mode the corresponding symbol on the display lights up and the stove shuts down
automatically when the room temperature T has reached the set value (Tset + ΔT) for a given time.
The next restart in automatic will be possible only when the room temperature falls below the set value by a few
degrees and precisely (Tset - ΔT) where ΔT default = 2°C.
With the OFF selection, the modulation function is active but not the STANDBY mode. Therefore when the
temperature exceeds the set value the stove will operate at minimum power.
4.6.6 Menu 06 – buzzer
With this selection it is possible to activate or deactivate the stove alarm buzzer.
4.6.7 Menu 07 – initial loading
Allows the preloading of pellets for a given time. This function can only be activated when the stove is off and cold
and is used if the auger is empty due to no more pellets. It is started with button P1 and stops with button P4.
4.6.8 Menu 08 – stove status
This selection is reserved exclusively for the authorised service centre technician.
4.6.9 Menu 09 – settings by technician
This selection is reserved exclusively for the authorised service centre technician.
Modification of the technical parameters of menu 09 must be done by an authorised and competent
technician; any modifications made randomly can cause serious damage for which declines any liability.

4.7 Remote control

The remote control works with the settings made in the control panel and allows stove lighting-shutdown, and
adjustment of the required output and temperature.
Since this device transmits through an infrared diode, it must be pointed at the receiver unit in the control panel.
The remote control allows the following operations:
P1 and P3: Buttons to set the power
level
P5: Button to activate/deactivate the
COMFORT function
power level activation)
P7: Button to activate/deactivate the
MAGIC CLEANING function
P9: On/Off button and for exiting the
MENU
P5 - COMFORT function: pressing this button forces power and ventilation onto P1. Deactivating this function will
take the power and ventilation to the value prior to activation.
This function observes and performs STANDBY.
P6 - QUICK function: pressing this button forces the machine power onto P5, saving the previous set power.
Ventilation, too, if present, is forced onto AUTOMATIC (so maximum ventilation); saving the previous ventilation
value. When pressed with the comfort function activated, it restores power and ventilation to the previous saved
value. With set ambient or set water satisfied the heater modulates P1 power together with ventilation.
(minimum
P2 and P4: Buttons to set the room
temperature
P6: Button to activate/deactivate the
QUICK function
P8: Button to activate/deactivate the
TURBO function
P10: Button to enter the MENU
37 AMBRA