Wolf Garten 41 BA Mode D'emploi page 14

Operation
Operating times
Please check noise abatement regulations prevailing in your
country.
Starter cord assembly
1. Lift and hold operator presence bail arm
2. Pull the starter rope slowly to the holding bracket.
3.
Twist the cord through the holder
3
Always remove the starter cord from the holder before
folding the mower handles.
Oil Fill
1
Check oil level with mower standing on level ground.
Fill crankcase with quality oil SAE 30 up to the mark „Full"
on dipstick. (Do not overfill.) Capacity approx. 0,6 litre.
Screw in dipstick.
Filling with fuel
1
Caution! Rotating blades
Settings only to be carried out on the machine with the mo-
tor switched off and with the working tools at a standstill.
Use only normal lead-free petrol.
Avoid spilling petrol.
Do not inhale the vapour.
Hang up collection bag
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
See illustrations F .
Set cut height
G
1
Attention! Rotary cutter blade
Undertake work/adjustments on the equipment only after
the motor is switched off and the cutting tool has come to a
standstill.
Flip over the control lever to make adjustments (1).
You can change the setting after moving the lever to the top
position. Carefully exert pressure on the "foot step" to lower
the mower and adjust the cutting height (2). A dial shows the
set cutting height (3).
Selection of Cutting height
If possible, mow when grass is dry in order to protect turf. Do
not set cutting position too low when mowing very hight or wet
grass.
We recommend an average cutting height of 40-50 mm.
14
B (1).
C
.
Start
On a flat surface, if possible not in high grass.
D
1. Open gas cock .
2. Raise and hold the safety bracket
E
3. Pull starter grip and return it slowly by hand.
Wheel drive
1. Wheel drive on: Raise drive bracket
2. Wheel drive off: Relapse drive bracket
Stop Motor
Release safety bracket.
Emptying of Grassbox
When the collection bag is full, the flap lowers by itself
1
Attention! Rotary cutter blade
Undertake adjustments on the equipment only after the
motor is switched off and the cutting tool has come to a
standstill.
Empty collection bag
Remove potential blockages in the cutting space before
starting.
Tips for mowing
To prevent strips of grass from being left unmowed, the cutting
paths must always overlap a few centimeters
B
(1).
B (2).
B
(2).
H
J .
K .
.
G