The Basic Menu; General; Accessing The Basic Menu - Fronius Galvo 1.5-1 208 Instructions De Service

The Basic menu

General

The following important parameters are set in the Basic menu for the installation and op-
eration of the inverter:
-
-
-
-
-
Accessing the
Basic menu
38
DC operating mode
Fixed voltage
MPPT1 initial voltage
USB logbook
Event meter
A c c e s s C o d e
M P P T r a c k e r 1
U S B E v e n t l o g
S M S / R e l a y
G r o u n d i n g S e t t i n g s
I n s u l a t i o n S e t t i n g s
- Ground mode / ground monitoring
- Insulation settings
- Temperature warning
- TOTAL reset
Press the "Menu" key.
1
The menu level is displayed.
Press the unassigned "Menu / Esc"
2
key
5 x.
In the "CODE" menu, the "Access Code"
is displayed; the first digit flashes.
Enter code 22742: Use the "Up" and
3
"Down" keys to select a value for the
first digit of the code.
Press the "Enter" key.
4
The second digit flashes.
Repeat steps 3 and 4 for the second,
5
third, fourth and fifth digit in the code
until...
...the set code flashes.
Press the "Enter" key.
6
The Basic menu is shown.
Use the "Up" and "Down" keys to se-
7
lect the desired item.
Edit the selected item by pressing the
8
"Enter" key.
Press "Esc" to exit the Basic menu.
9