Astralpool NanoFiber 64837 Manuel D'installation Et D'entretien page 4

POSITION OF THE CARTRIDGE:
The cartridge comes properly fitted from the factory.
If you wish to remove the filter in the future, follow the steps described below:
1. Stop the filtration pump and set the valve to the Off position.
2. Open the drainage cap and release the air.
3. Unscrew and remove the cover assembly.
4. Remove the cartridge.
5. Put a new cartridge in place, check that it
is well secured and that it can be turned with
your hand.
6. Put the seal in place and check that it is
firmly in position.
7. Screw the cover assembly back in.
8. Set the valve to the Filtration position.
9. Close the drainage cap until there is no lon-
ger any air inside the filter.
Warning: when the filter is running check that no
water leaks from the lid.
Note: the manufacturer takes no responsibility for
any damage to the filter when the cartridge is being
changed.
SELECTOR VALVE:
We recommend that the nanofiber filter be fitted together with an AstralPool multiport valve (code 07444).
The selector valve has a handle of 6 positions that selects any of the necessary operations to obtain the
maximum efficiency from the filter.
IMPORTANT: Always switch off the pump, when changing the position of the selector valve.
START-UP:
The first time, proceed as follows:
1.- Open the air bleed cap to blow out the air.
2.- Place the selector valve in the "FILTER" position.
3.- Open the valves controlling the swimming pool suction pipes.
4.- Close the air bleed cap when water starts to come out.
5.- Run the pump and the filter will be ready to start the filtering cycles for the water in the swimming
pool.
IMPORTANT: The pump should be switched off when the position of the selector valve handle is being
changed.
FILTRATION:
With the pump switched off, place the handle of the selector valve in the "FILTERING" position.
Switch on the pump.
4