Set Date And Time - Virax 570010 Manuel D'utilisation

 Use the adjusting knob (4) to select the desired parameter, P101 to P114. If this value must be adjusted or
displayed, briefly press the adjusting knob (4). The (default) value blinks in the lower display (9).
 Use the adjusting knob (4) to set the value, and press the adjusting knob (4) briefly again. Then the
parameter blinks again in the upper display (2).
Parameter
name
P001 Remaining energy saver time
P002* Power saving function active
P003 Heating plate temperature offset
P004 Pmax for cutting
P005 Target pressure
P006 Target temperature
P007 Timer T1 target value
P008 Timer T4 target value
P009 Pstart for cutting
P101 Deviation for repumping
P102 Lifting time after cutting
P103 Set temperature (min)
P104 Set temperature (max)
P105 Button lock (yes/no)
P106 Lifting pressure
P107 Full runtime until buzzer goes on
P100 Change code
 To leave the menu, press the release button (10). The values are stored
* P002 – Power saving function:
0 - none,
1 - when the miller is running the heating element will be switched off,
2 - when the hydraulic motor is running the heating element will be switched off,
3 - when t4 is running the heating element will be switched off..

3.6. Set date and time

 Close the program by clicking briefly in the upper left corner.
Description
Page 55
Default Unit
99 min
0
5 °C
20 bar
1/10 bars
210 °C
45 sec
6 min
10 bar
5 %
10 1/10 sec
160 °C
270 °C
5 sec
135 bar
50 1/10 sec
8001
min max Rights
0 99 Welder
0 3 Welder
-25 25 Welder
10 50 Welder
Welder
P103 P104 Welder
1 1500 Welder
1 99 Welder
0 P004 Welder
1 50 Master
0 100 Master
0 300 Master
0 300 Master
0 50 Master
10 160 Master
0 200 Master
Master