Virax 570010 Manuel D'utilisation page 49

 After the cutting shavings continuously exit the cutting bit with a shaving thickness of <= 0.2 mm, press the
Cutting button (5) and open the clamping elements (Press buttons 10 + 8).

Wait until the cutting disks have stopped. Remove the cutting unit from the basic machine and put it in the
storage case.
 Use low pressure to bring the work pieces together (press buttons 10 + 11) and set the drag pressure with
the adjusting knob (4).
 When the machine is running at low speed, press the screen. The measured drag pressure will automatically
be added to the equalization, warm-up and cutting pressure.
 Close the clamping elements, set the correct pressure for the pipe, and check to see if the work pieces are
firmly held in the clamping tools
The arrow keys take the program back to „Please insert the trimmer..."
EXIT takes the program to the main menu without saving.
Page 49