Virax 570010 Manuel D'utilisation page 42

 Start the welding process with GO.
In this final overview, the last changes can be made by clicking on the relevant subpoint and confirming with GO.
In CNC mode, control is executed by the touch PC. All functions outside the touch PC, except for the power key
(6), are blocked.
The welding process can be cancelled by the power key. The key lock is then raised and the relevant message
appears in the display.
Pressing the arrow key causes the machine to start up; pressing EXIT causes the program to spring into the main
menu without saving.
 Place the electrical cutting unit between the two work pieces to be welded.
P250 – P355 B PRO CNC: Switch on the miller motor and lock the switch in place.
P500 - P630 B PRO CNC: Verify the direction of rotation! The machines were polarized to turn clockwise
before leaving our factory!

Switch on the milling unit by pressing the text field. The cutting disks must run in the cutting direction. If they
don't, use an appropriate tool to switch the phase inverter on the electrical plug.
Risk of serious injury! During operation trimmer unit, stay a safe distance away from the machine,
and do not reach into the rotating knife. Use trimmer in working position only and return it into
the designated carrying frame immediately after use. Ensure that the safety switch functions
properly at all times to avoid any accidental starting of the trimmer away from the basic machine.
Page 42