Virax 570010 Manuel D'utilisation page 43

 Clamping elements move together automatically. The cutting pressure can be increased with the rotary knob
(4). Standard cutting pressure is up to 20 bar, but it can be raised to 50 bar, see point 3.5.
An excessively high milling pressure can lead to overheating and damage to the miller drive. When
the milling drive is overloaded or at rest, raise the machine and reduce the pressure (s. 3.5).
 After the shavings with a chip thickness of < = 0.2mm are discharged continuously from the milling cutter,
press on text field. Milling unit is switched off and the clamping elements start up.
 Wait until the cutting disks have stopped. Remove the cutting unit from the basic machine and put it in the
storage case.
 Press text field, the work pieces move together and the drag flow pressure is measured
 The measured drag pressure will automatically be added to the equalization, warm-up and cutting pressure
Stay a safe distance away from the machine. Do not stand or reach into the machine. Keep
other people away from the work area.
The arrow keys take the program back to „Please insert the trimmer..."
EXIT takes the program to the main menu without saving.
Page 43