Virax 570010 Manuel D'utilisation page 39

Pressing longer on the button (7) shuts off the heat. The dot on the display (9) goes off. Pressing again turns the
heat back on.
Hydraulic unit P500 - P630 B PRO CNC : Check the direction of rotation! The machines are clamped
to turn clockwise at the factory. Open and close the machine with the hydraulic unit. If there is no
movement, use an appropriate tool to switch the phase inverter on the electrical plug.
Note: Do not turn the hydraulic unit on if the direction of rotation is wrong (this may destroy it).
 Enter or select the welder name "Operator".
In the entry form, saved welders can be selected, new welder names can be entered, and existing welder names
can be deleted with DEL and reentered. All entry forms are confirmed and saved with the ENTER or OK button,
and the next program step is called up. The EXIT button closes the entry form without saving it.
 Enter or select a project.
The entry forms can be used to select saved projects or enter new project names. Close and save using the
ENTER key.
Page 39