Control Panel And Features - Maytag W10280548E Guide D'utilisation Et D'entretien

CONTROL PANEL AND FEATURES

1
1 WATER LEVEL
Select the setting most suitable for your load. Small will add
a low amount of water for smaller loads and Super Plus will
add the most amount of water for large or bulky loads. Items
need to move freely. Tightly packing can lead to poor cleaning
performance, and may increase wrinkling and tangling.
TEMPERATURE
2
Temperature Control senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and soils
being washed. For best results and following the garment label
instructions, use the warmest wash water safe for your fabric.
• Warm and hot water will be cooler than what your previous
washer provided.
• Even in a cold and cool water wash, some warm water may
be added to the washer to maintain a minimum temperature.
WASH CYCLE KNOB
3
Use the Wash Cycle knob to select available cycles on your
washer. Turn the knob to select a cycle for your laundry load.
See "Cycle Guide" for detailed descriptions of cycles.
FABRIC SOFTENER
4
This option can be added to most cycles and must be set to
"YES" if using fabric softener during a cycle. It ensures that
fabric softener is added at the correct time in the rinse for
even distribution.
START/PAUSE/UNLOCK BUTTON
5
Press to start the selected cycle; press again to pause the cycle
and unlock the lid.
NOTE: If the washer is spinning, it may take several minutes to
unlock the lid. Press and hold for 3 seconds to cancel a cycle.
CYCLE STATUS LIGHTS
6
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that are
different from traditional washers.
4
2
Not all features and options are available on all models.
Appearance may vary.
3
6 5
SENSING
When the START/Pause/Unlock button is pressed, the
water will enter washer briefly, pause, and then lock before
sensing process begins. The washer will use spins to check
for load balance. The sensing process may take 2-3 minutes
before steady flow of main wash water. You may hear the
hum of the spins before filling. This is normal.
WASH
You will hear the agitator moving the load. The motor
sounds may change at different stages in the cycle. The
wash time is determined by the selected soil level.
RINSE
You will hear sounds similar to the wash cycle as the washer
rinses and moves the load. You may hear the motor turning
on briefly (short hum) to move the basket while filling.
Fabric softener will be added if the Fabric Softener-Yes
option was selected.
Some cycles use spray rinsing. After draining and spinning
out wash water, the washer will continue to spin and spray
in rinse water for the entire rinse time.
SPIN
The washer spins the load at increasing speeds for proper
water removal, based on the selected cycle and spin speed.
DONE
Once the cycle is complete, this light will come on.
Remove the load promptly for best results.
LID LOCKED
To allow for higher spin speeds, the lid will lock and the
Lid Locked light will turn on. When this light is lit, the lid is
locked and cannot be opened. When this light is blinking,
the washer is paused. When this light is off,
the lid can be opened.
If you need to open the lid, press
START/Pause/Unlock. The lid will
unlock once the washer movement
has stopped. This may take several
minutes if the load was spinning at
high speed. Press START/Pause/
Unlock again to resume the cycle.
4