Changing The Baffle Plate; Changing The Burn Plates; Optional Equipment - Jotul F 500 Manuel D'installation Et Données Techniques

ENGLISH
4.0 Service
Warning! Any unauthorised change to the product is illegal. Only
use original spare parts.

4.1 Changing the baffle plate

1. The baffle plate consists of a vermeculite plate, and rests on
top of the pipes that supply secondary air.
2. To remove, just lift it off and out
3. To install, follow the same procedure in opposite sequence.
Make sure the vermeculite plate is fitted closely against the
back wall. Be aware that the vermiculite plate may be damaged
by rough handling.
4. Then place the insulating blanket on top of the baffle plate.

4.2 Changing the burn plates

1. The stove has burn plates that are mounted to the sides and
fire bricks in the back.
2. Unfasten the screws and remove the burn plates. To reinstall,
make sure the insulation is properly fastened to back of the
burn plates.
3. The bricks at the back are easy to change. Simply lift up a
little and pull out.
16

5.0 Optional equipment

5.2 Connecting pipe for outdoor
ventilation - Cat. No. 221031
With the aid of a connecting pipe for outdoor ventilation and a
flexible tube, combustion air can be connected to the product
directly from the outside. In this manner, the fireplace will always
be supplied with the air needed to achieve proper combustion.
Fresh air supply direct from the exterior or from the chimney
with air vents
1. Insert the connecting pipe into the air inlet under the
product.
2. Unfold the pipe"s 3 flaps
3. Attach a flexible tube (Ø 80 mm) directly to the fireplace's
connecting pipe by using a hose clamp and attach it to the
wall outlet/chimney.
5.2 Rear heat shield- Cat.No. 350956
Assembly instruction follows the product.
(fig. 5A) inside the air inlet.