Blade Care - BaByliss PRO SKELETON FX FX7870BKE Mode D'emploi

the teeth of the trimmer are facing
down. Place the trimmer on a flat
surface and using the screwdriver,
loosen the fastening screws from
the blade set. Remove the blade
set from the trimmer (see Fig. 1).
Fig. 1
Blade set
Blade screws
To install or replace your trimmer
blade set, reverse the procedure,
aligning the blade cushion shaft
into the moving blade cushion
(see Fig. 2). With the blade held in
place, replace blade screws and
tighten loosely. Turn the trimmer
over and align the blade set paral-
lel to the trimmer's upper housing.
Fig. 2
Screws
Moving blade
Fixed blade
Screws
Screw holes

BLADE CARE

Because the trimmer blades are
Blade cushion
precision-made for a very special
use, they should always be handled
with care and cleaned regularly to
ensure maximum performance.
Each time you finish using the trim-
mer, take the cleaning brush provi-
ded and brush away any loose hair
that has collected in the blades. Use
a clean cloth to dry the attachment,
reattach and then store the trim-
mer to protect the blades until the
next use.
Any other servicing should be per-
formed by an authorized service
representative, since the appliance
has no other user-serviceable parts.
This product is for professionall
use.
DO NOT RINSE BLADE OR TRIM-
MER HANDLE OR ADAPTER.
ZERO GAP ADJUSTMENT TOOL
IMPORTANT! Only ever attempt
to zero gap the blades using the
adjustment tool, following the ins-
tructions very precisely.
The adjustment tool is required to
adjust the blades to zero gap, to
achieve a closer, more precise cut.
Step 1 – Using the screwdriver
included, gently loosen the two
small screws on each side of the
blade.
8