On/Off Switch - BaByliss PRO SKELETON FX FX7870BKE Mode D'emploi

ENGLISH
PROFESSIONAL OUTLINER
EDM TECHNOLOGY
FX7870BKE-FX7870RE
Adaptor
Vibrations
LpA (dB(A))
OPERATING INSTRUCTIONS
1. Before using the trimmer for the
first time, charge continuously for 3
hours. Maximum battery capacity
will only be reached after 3 char-
ging and discharging cycles.
2. Make sure the switch on the trim-
mer is in the «0» position.
3. Apply a drop of the provided lu-
bricating oil across the blades; wipe
off any excess oil with a dry cloth.
4. Connect the charging jack into
the receptacle on the bottom of the
trimmer. Plug the adapter into any
electrical outlet. The charging indi-
cator will light up to indicate that
the charging has begun. Charging
is complete after 3 hours. User will
see LED light has stopped blinking
and is now steady lit.
5. The adapter may become warm
while charging. This is normal.
6. Preserving the batteries: In order
to maintain the optimum capa-
city of the rechargeable batteries,
the trimmer should be recharged
for 3 hours approximately every 6
months.
7. Slide the switch to «I» position.
8. Make sure the switch is in the «0»
position when the trimmer is not
CA80M
< 2,5 m/s²
< 70
operating.
9. Remove hair trimmings and
debris from the blades using the
provided cleaning brush. Wipe the
housing clean with a dry cloth.
10. Apply a few drops of lubricating
oil to the blades, and wipe off any
excess oil with a dry cloth. This last
procedure is important for the pro-
per maintenance of the blades.
11. If the charging light starts to
flash rapidly (more than 4 flashes
per second) then the appliance is
faulty. If this happens then please
stop charging and remove the
adapter from the mains and contact
an authorized Service Center.
FOR DIRECT PLUG-IN OPERA-
TION
Make sure trimmer is off. Connect
charging jack into the receptacle
at the end of trimmer and plug the
adapter into power outlet.

ON/OFF SWITCH

To operate, simply slide switch to
«I» position. To stop operation, set
to the «0» position.
VERY IMPORTANT:
MUST BE CLEANED AND OILED
ON A REGULAR BASIS FOR PRO-
PER FUNCTIONING. FAILURE TO
REGULARLY CLEAN AND OIL THE
BLADES WILL VOID THE WAR-
RANTY.
REPLACING (REMOVING) BLADE
SET
To remove
FX7870RE blade set, turn the trim-
mer to the OFF position and unplug
it from the electrical outlet. Turn
the trimmer upside down so that
7
BLADES
the FX7870BKE-