Operating The Appliance; Electronic Clock; Clock Display - CONSTRUCTA CH132253 Mode D'emploi

Changing the clock
To subsequently change the time, press the KJclock function
button repeatedly until the KJ and 3 symbols light up again.
Change the time with the rotary selector.
Cleaning the appliance
Clean your appliance before using it for the first time.
Remove accessories and any remaining packaging from the
1.
cooking compartment.
Clean the accessories and cooking compartment with hot
2.
soapy water (see section: Cleaning and care).

Operating the appliance

In this section, you will find out how to switch your appliance on
and off, and how to select an operating mode and temperature.
Switching on the appliance
Turn the operating mode selector until the desired operating
1.
mode is selected.
Turn the temperature selector until the desired temperature is
2.
selected.
The r indicator lamp lights up while the appliance is heating
up and during any subsequent heating.

Electronic clock

In this section, you can read about
how to set the timer
■
how to switch off your appliance automatically
■
how to switch your appliance on and off automatically
■
(preset operation)
how to set the time
■
Clock function
Minute minder
Q
Cooking time
x
End of operation
y
Preset operation
Clock
3
Notes
Between the times ƒƒ:‹‹ and †:†Š the clock display is
■
dimmed if you do not make any settings in that period or no
clock function is activated.
When you set a clock function, the time interval increases
■
when you set higher values (e.g. cooking time up to‚:‹‹œ to
the minute, using ‚:‹‹œ
to the nearest 5 minutes).
Use
You can use the minute minder as an egg timer or a kitchen timer. The appliance does
not switch on or off automatically
The appliances switches off automatically after a cooking time setting has elapsed
(e.g. ‚:„‹ hours)
The appliance switches off automatically at a set time (e.g. ‚ƒ:„‹ o'clock)
The appliance switches on and off automatically. Cooking time and end of operation
have been combined.
Setting the clock
Heat with % Top/bottom heat at 240°C for 60 minutes.
3.
Afterwards, wipe the cooled cooking compartment with hot,
4.
soapy water.
Clean the outside of the appliance with a soft, damp cloth
5.
and soapy water.
Switching off the appliance
Turn the operating mode selector back to the Û position.
1.
Turn the temperature selector back to the Ú position.
2.
After the appliance is switched off, the cooling fan may
continue to run.
Switching the hob on and off
Your hob comes with its own instructions for use. This contains
important safety information, detailed set-up instructions and a
lot of information on care and cleaning.

Clock display

For the Q minute minder, x cooking time, y end of
■
operation and preselection mode clock functions, a signal
sounds when the settings have elapsed and the Q or y
symbol flashes. To cancel the audible signal before it ends,
press the KJ clock function button.
Briefly press the KJ clock function button to select a clock
■
function. You then have 3 seconds to set the selected clock
function. After this time, the setting mode is exited
automatically.
57