Recall Function; "Keep Warm" Function; Control Panel Locking - BORETTI BIKP-79 Notice D'emploi

Recall Function

After switching off the hob [
 cooking stages of all cooking zones (power)
 minutes and seconds of programmed cooking zone-related timers
 Heat up function
 Keep warm function
The recall procedure is following:
 Press the key [
 Then press the key [ II ] within 6 seconds
The precedent settings are activated.

"Keep warm" Function

This function allows to reach and maintain automatically a temperature of 42°C or 70°C.
This will avoid liquids overflowing and fast burning at the bottom of the pan.

To engage, to start the function "Keep warm":
Action
Zone selection
42°C to engage
70°C to engage
To stop
This function can be started independently on all the heating zones.
When the pan leaves the cooking zone the "Keep warm" function remains active during
approximately 10 minutes.
The maximum duration of keeping warm is 2 hours.

Control panel locking

To avoid modification of the setting of the cooking zones, in particular during cleaning, the control
panel can be locked (with exception to the On/Off key [

Lock:
Action
Start
Locking the hob
Once the hob locked, a 10 seconds countdown starts. During this countdown, you can unlock the
hob. Once past this time, the release becomes impossible, you must shut down and re-ignite the
hob. At each selection of [ P ] key, a segment of [ L ] appears. The hob is locked when the [ L ] is
complete.

Unlock:
Action
Start
In the 10 seconds after start:
Unlock the hob
At each selection of [ P ] key, a segment of [ L ] disappears. The hob is unlocked when the [ L ]
disappears.
], it is possible to recall the last settings.
]
Control panel
Press display [ 0 ] selected
Press on key [ U ]
Press on key [ U ]
Slide on the "SLIDER"
Control panel
press on key [ ]
Hold a finger on the "SLIDER"
and press 3 times on the [ P ]
Control panel
press on key [ ]
Hold a finger on the "SLIDER"
and press 3 times on the [ P ]
60
Display
[ 0 ] to [ 9 ] or [ H ]
[ ]
U
[ U ]
[ 0 ] to [ 9 ] or [ H ]
]).
Display
[ 0 ] or [ H ]
[ L ]
Display
[ L ]
[ 0 ] or [ H ]