Panasonic ES7109 Manuel D'utilisation page 9

Cleaning with the self-cleaning recharger (continued)
1 1 1 1
1 Follow the steps outlined below if the status lamp blinks or glows
during the "Clean/Dry/Charge" course or the "Clean/Dry" course.
Blinks
Correctly set the
detergent cartridge and
then restart a course.
If the status lamp goes
out
Continue a course.
When an abnormality has
been corrected
Press and hold [select] for
approximately  seconds to
turn off the status lamp and
then restart a course.
When the status lamp
goes out
Continue a course.
Glows
Remove the shaver from the self-
cleaning recharger and then
check that the [clean] lamp has
gone out. (Be careful as the blade
may be hot or wet.) Check that
the water tank is correctly
attached, the water tank cap is
securely closed and the self-
cleaning recharger is placed
horizontally.
When no abnormality was
found
It is time to replace the
detergent cartridge and
cleaning liquid inside the water
tank.
Drain the old cleaning liquid
inside the water tank and then
refill it with water. Replace the
old detergent cartridge and
then restart the course.
When the status lamp glows
again
Contact an authorized service
center.
Cleaning the shaver without the self-cleaning
recharger
1. Disconnect the power cord
. Apply some hand soap to the
3. Turn the shaver on and then
4. Turn the shaver off after 10-0
5. Remove the foil frame and
6. Wipe off any drops of water
7. Remove the system outer foil
from the shaver.
outer foil.
pour some water over the
outer foil.
seconds.
clean it with running water.
with a dry cloth.
and the foil frame to allow
them to dry completely.
9