Dentification Of Omponents; Safety Devices - Comet KS 1600 Extra Manuel D'utilisation Et D'entretien

2.1 I
DENTIFICATION OF
Please also refer to figures 1 to 4, which are located at the start of these operating and maintenance
instructions.
1. Switch
2. Electrical wire + plug
3. Pressure indicator
4. Detergent tank filling plug (only KS 1700)
5. Water outlet connection
(only CLASSIC)
6. Hose reel (only EXTRA)
7. High-pressure hose
8. Water gun
9. Water gun lever
10. Water gun lever safety lock
11. Lance hose
12. Nozzle-holding multi-adjusting head
13. Knob and hose reel lever (only EXTRA)
14. Water suction connection
15. Water suction filter
2.2 S D
AFETY EVICES
This water cleaner is provided with the following safety devices:
a) Amperometric protector
This blocks the operation of the water cleaner in case of excessive consumption of electrical
current.
In this case, proceed as follows:
- switch the main switch (1) to position "0" and remove the plug from the power outlet;
- press the lever (9) on the cleaner gun to eliminate any remaining pressure;
- wait 10 to 15 minutes until the water cleaner cools down;
- check that the instructions in the "
" section have been followed, particularly regarding any extension cord used;
SUPPLY
- replace the electric plug in the power outlet and repeat the start-up procedure described in the
" " section.
OPERATION
fi«
CAUTION
• If this safety device cuts in repeatedly, do not use the water cleaner until it has been checked
by a Skilled Technician.
b) Pressure limit/adjustment valve
When this valve has been correctly set, the pumped fluid is able to return to the pump's suction
unit, thus preventing the creation of dangerous levels of pressure when the cleaner gun is stopped
or should pressure be set that is above allowed levels.
c) Safety stop on cleaner gun lever
This safety device (10) shuts and blocks the lever on the cleaner gun (9) to prevent the possibility
of it being started by accident (also see Fig. B)
C
OMPONENTS
CHECKS AND CONNECTION TO THE MAINS ELECTRICITY
16. Setscrew wrench for nozzle disassembly
17. Pin for nozzle cleaning
18. Technical data plate
19. Room for housing the lance pipe
20. Room for housing the water gun
21. Support to wind the electrical wire
22. Rotojet (only EXTRA)
23. Guaranteed sound power plate
24. Hose reel locking (only EXTRA)
25. Water cleaner/hose reel connecting hose (only EXTRA)
26. Accessory support (only EXTRA)
27. Caution plate
28. Thermal switch
29. Warning plate
30. Handlebar
31. Foaming lance (only KS 1600)
27