Torage; Cleaning And Maintenance; Outine Aintenance - Comet KS 1600 Extra Manuel D'utilisation Et D'entretien

6.2 S

TORAGE

• Wind up the high-pressure pipe (7) carefully and avoid bending it.
• Wind up the electric power supply cable (2).
• Put the water cleaner in a clean and dry place making sure that the electric power supply cable
and the high-pressure pipe are not damaged.
WARNING
• The water cleaner is not frost proof.
In order to prevent the formation of ice inside the water cleaner in cold areas, it is possible to
make the high pressure cleaner take up a motor vehicle grade anti freeze before starting the
"Switch off" procedures. Contact a Skilled Technician before attempting this as the pumped
liquid could damage the seals in the high-pressure pump.
If it is not possible to protect the high pressure cleaner in cold areas as described above, it must
be brought into a warm room for the time required to melt any ice which may have formed
inside it before attempting to start it up again.
If these instructions are not followed, the high pressure cleaner may be seriously damaged.
7 C
LEANING AND
fi«
CAUTION
• Only start cleaning and maintenance once the instructions in the "Switching off" section have
been completed.
It is particularly important to always disconnect the electricity supply.
• To safeguard the safety of the high pressure cleaner, only use the original spare parts supplied
by the Manufacturer or those endorsed by him.
• The rubber pipes, the coupling and the high-pressure lances are important for safety: only use
those endorsed by the Manufacturer.
7.1 R M
OUTINE AINTENANCE
Follow the instructions in the "Switching off" section and abide by the recommendations in the
table below.
INTERVAL FOR MAINTENANCE
Each time used
Weekly
Monthly
34
M
AINTENANCE
ACTION
• Check the supply cable, high-pressure pipe, couplings, cleaner gun,
lance pipe.
Should any of these parts appear to be damaged, do not use the high
pressure cleaner and contact a Skilled Technician.
• Clean the water inlet filter (15).
Usually, it is sufficient to pass the filter under running water or in a jet of
compressed air to clean it. In more difficult cases, use a lime scale remover
or replace the filter. Contact an authorised service centre for the purchase
of a new filter.
• Clean the nozzle.
For cleaning, it is generally enough to pass the supplied pin (17) inside the
nozzle hole. In case you do not obtain any appreciable result, replace the
nozzle by using the supplied wrench 16. For purchasing the spare part,
apply to an authorised service centre.