Witching Off; Nterrupting Se Total Stop; Switching Off And Storage - Comet KS 1600 Extra Manuel D'utilisation Et D'entretien

• When filling the tank with detergent, take care not to spill any detergent on the high pressure
cleaner. If this should happen, wait at least 24 hours before using the high pressure cleaner
so that any liquid, which may have entered the appliance, can evaporate.
The recommended detergents, are over 90% biodegradable.
For information on how to use the detergents, refer to the instructions in the table below and on
the label on the container of detergent.
• In case of suction from the water cleaner tank (only KS 1700):
- Remove the plug (4) and, by paying attention that the fluid does not overflow, fill the tank
(maximum capacity 1.75l/0.46 US gal.) by following the recommendations relating to the
proportion indicated on the detergent package label.
- Operate the nozzle-holding multi-adjusting head (12) as shown in Fig. H-1 and activate the
water gun lever (9) and start the detergent spraying operation.
- Operate the nozzle-holding multi-adjusting head (12) as shown in Fig. H-2 to reset the high-
pressure operation.
• In case you use the foaming lance (31) (only KS 1600), insert it on the water gun (8) and switch
on the device (the suction and the mixing take place automatically when the water flows by).
5.4 I U
NTERRUPTING
Release the lever (9) on the cleaner gun and the water cleaner will automatically stop.
The water cleaner starts operating normally again when the lever on the cleaner gun is pressed
again.
fi«
CAUTION
• It is important to remember that the high pressure cleaner is still operational when it is in Total
Stop mode. Therefore, always put the main switch (1) in position "0", remove the plug from
the power outlet, press the lever (9) on the cleaner gun to eliminate any remaining pressure
and lock the safety protection device (10) (Fig. B), before leaving it unattended, even for a
short time.
6 S O
WITCHING
After cleaning, switch the water cleaner off and prepare it for storage.
6.1 S O
WITCHING FF
• Close the tap for the water supply securely.
• Empty the water out of the water cleaner by pressing the lever (9) on the cleaner gun for a few
seconds.
• Put the main switch (1) in position "0"
• Remove the plug from the power outlet.
• Press the lever (9) on the cleaner gun to eliminate any remaining pressure in the high-pressure
pipe (7).
• Rewind the power supply cable (2) with care and hook it to its support (21).
• Wait for the high pressure cleaner to cool down.
fi«
CAUTION
• When the water cleaner is left to cool down, take care that:
- the water cleaner is not left unattended in the presence of unsupervised children, elderly
or disabled people.
- the water cleaner is in a stable position and not at risk of falling over.
- the water cleaner is not in contact with inflammable materials, or in their immediate
vicinity.
( )
SE TOTAL STOP
S
FF AND TORAGE
33