Address Of The Manufacturer; 1.4.2 Terms - Comet KS 1600 Extra Manuel D'utilisation Et D'entretien

The Manufacturer reserves the right to make any modification at any time which it deems necessary
to improve the product and is not liable to make these modifications to previously manufactured
products, be they delivered or under delivery.
The conditions in this section exclude any previous explicit or implicit condition.
1.2 A
DDRESS OF THE
The address of the manufacturer is given in the declaration of conformity at the end of this part
of the instruction manual.
1.3 U A C
SE ND ONSERVATION OF THESE
The operating and maintenance instructions are an integral part of the water cleaner and they must
be kept in a safe place for future reference so that they may be readily consulted in case of need.
The operating and maintenance instructions contain important information for the safety of the
operator and of any people near him and for the protection of the environment.
In case of deterioration or loss, a new copy should be requested from the dealer or from an authorised
service centre.
If the water cleaner is passed on to a third party, please make sure these operating and maintenance
instructions are also given to the new owner.
We take great care when drawing up our instructions. If you note any mistakes, please do inform
the Manufacturer or an authorised service centre.
The Manufacturer reserves the right to modify, update and correct these instructions without
notice.
It is illegal to copy these instructions, even partially, without prior authorisation by the
Manufacturer.
1.4 S T
YMBOLS AND
1.4.1 Symbols
The symbol:
fi«
CAUTION
next to certain parts of the text, is to indicate that there is the firm possibility of injury to persons
if the relative instructions and indications are not followed.
The symbol:
WARNING
next to certain parts of the text is to indicate that there is the possibility of damaging the water
cleaner if the relative instructions are not followed.

1.4.2 Terms

• Skilled Technician: a person, generally from the service centre, who has received appropriate
training and is authorised to carry out special maintenance and repairs on the water cleaner. Any
work on is electrical parts must be carried out by a Skilled Technician who is also a Qualified
Eletrician, i.e. a person with professional training who is authorised to check, install and repair
electrical equipment correctly and according to current regulations in the country where the
water cleaner is installed.
• Total Stop: this stops operation of the water cleaner every time the control lever on the cleaner
gun is released.
• By-pass: means the particular operating mode of the water cleaner that is achieved when the
lever of the cleaner gun is released during normal operation. In this condition, the pressure gauge
M
ANUFACTURER
ERMS
O M
PERATING AND
M
AINTENANCE ANUAL
25