Dentification Of Omponents; Safety Devices - Comet KSM Manuel D'utilisation Et D'entretien

2.1 I
DENTIFICATION OF
Please also refer to figures 1 to 2, which are located at the start of these operating and maintenance
instructions.
1 Water inlet fast connector
2 Main switch
3 Hose reel lever (only EXTRA)
4 Hose reel (only EXTRA)
5 High-pressure hose for the hose
reel connection (only EXTRA)
6 Water outlet connector
7 High-pressure hose for the hose reel
(only EXTRA)
8 Accessory tray (only EXTRA)
9 Seat for water gun/lance hose
10 Plate "Read the manual before..."
11 Wire reel
12 Identification plate
13 Plate "Do not spray towards persons, ...."
14 Power supply wire
15 Plate "Guaranteed sound power"
2.2 S D
AFETY EVICES
This water cleaner is provided with the following safety devices:
a) Thermal protector
It's a device that stops the water cleaner operation in case of motor overheating.
In this case, proceed as follows:
- switch the main switch (2) to position "0" and remove the plug from the power outlet;
- press the lever (28) on the cleaner gun to eliminate any remaining pressure;
- wait 10 to 15 minutes until the water cleaner cools down;
- check that the instructions in the "
" section have been followed, particularly regarding any extension cord used;
SUPPLY
- replace the electric plug in the power outlet and repeat the start-up procedure described in the
" " section.
OPERATION
fi«
CAUTION
• If this safety device cuts in repeatedly, do not use the water cleaner until it has been checked
by a Skilled Technician.
b) Pressure limit/adjustment valve
When this valve has been correctly set, the pumped fluid is able to return to the pump's suction
unit, thus preventing the creation of dangerous levels of pressure when the cleaner gun is stopped
or should pressure be set that is above allowed levels.
c) Safety stop on cleaner gun lever
This safety device (29) shuts and blocks the lever (28) on the cleaner gun (16) to prevent the
possibility of it being started by accident (see also Fig. 2, pos. S)
C
OMPONENTS
CHECKS AND CONNECTION TO THE MAINS ELECTRICITY
16 Water gun
17 Lance hose
18 Nozzle-holding head
19 Nozzle cleaning hole
20 Rotating nozzle lance hose (only EXTRA)
21 Foaming lance
22 Cleaner suction adjusting device
23 Detergent bottle
24 High-pressure hose (only CLASSIC)
25 High-pressure hose fast connector
(only CLASSIC)
26 Water inlet filter
27 Water inlet fast connector
28 Water gun lever
29 Water gun lever safety stop
30 Handle
25